Polycom: Enabling the Web Interface
Written by Mira Beltre
Updated at September 20th, 2025
Table of Contents
Scope
Intended Audience: All users
This article outlines how to enable the Web Interface of a Polycom device from the phone's settings
Requirements
- Access to a Polycom device
Note: CCX 400 phones running software prior to UC Software 6.2.11 don’t support access to a system web interface.
How to Enable the Web Interface of a Polycom
- In your Polycom device, go to Settings
- Select Advanced
- Enter the Admin Password (if it is not yet provisioned the default is 456)
- Navigate to Web Server Configuration
- Enable the Web Server
- Configure Web Mode: (Choose the desired mode: HTTP Only, HTTPS Only, or HTTP/HTTPS. HTTPS provides more security than HTTP.)
- Save Changes
Accessing the Web Interface
- After enabling the web server, open a web browser on a computer connected to the same network as the phone.
- Enter the phone's IP address into the browser's address bar.
- Log in with the user credentials to access the Polycom Web Configuration Utility.