• Home
  • Hardware & Software
  • Manual Configuration

Snom: M300 Manual Configuration

Written by Marissa Orsini

Updated at April 25th, 2023

Contact Us

  • The Essentials
    FAQs Forms
  • Announcements
    Carrier Events mFax Events Platform Events Release Notes
  • Billing Administration
    Datagate OneBill
  • Faxing
    mFax - Analog mFax - Digital Native Fax
  • Hardware & Software
    Manual Configuration Provisioning NDP Axis Cisco Fanvil Grandstream Polycom Snom Yealink Mobile Applications Desktop Applications Mobile-X SNAPbuilder TeamMate Connector UC Integrator
  • Hosted Voice
    Auto Attendants Branding Call Queues Call Routing CDRs Conferencing E-911 Features Fraud Integrations Inventory / Phone Numbers Local & Toll Free Porting Onboarding Recommendations SNAP.HD SIP Trunking SMS / MMS Users Voicemail Caller ID
  • Troubleshooting
    VoIPmonitor Firewalls PBX
  • Ray's Stuff
+ More

Table of Contents

Configure Snom Base Phone

Scope:

The following document will show you how to manually provision Snom M300 Phone

 

Requirements:

  • Access to Snom web GUI 
     
  • Access to Manager Portal 
     
  • Phone's MAC address must already have been added to a user in the Manager Portal
 

 

Configure Snom Base Phone

  1. Using any web browser navigate to the IP address of the phone.
  2. Click on the Servers tab, click Add Server and populate the following fields, click Save
    1. Register : <domain>
    2. Outbound Proxy: <sbc>:5060 ( Refer to SBC Url here )
  3. Click on the Extensions tab, click Add Extension, and populate the following fields, Click Save
    1. Extension: <user extension>
    2. Authentication User Name: <Username>
    3. Authentication Password: <Password>
    4. Display Name: <User Extension>

      Note: These are the SIP Info you need for the extension
  4. Click on the Extensions tab, Click Handset -> Click Add handset
  5. Enter the IPEI of the handset, click Save
    To get the IPEI, on the handset, go to settings -> status -> scroll down and look for the IPEI 
  6. Click on the Extensions tab, Click the Handset tab, and check the checkbox next to the extension you added.  Click on Start SIP Registration.
  7. Now check the State of the extension, it should show SIP Registered.
  8. If it shows SIP Error, make sure you entered the correct SIP Credentials and check the SIP Log to make sure that it's sending the registration.  The SIP Log will give you some details on the SIP Messages error.

 

manual setup snom m300

Was this article helpful?

Yes
No
Give feedback about this article

Related Articles

  • Snom M100: Manual Configuration
  • Obihai 200/300: Manual Configuration
  • cnPilot R200/R201: Manual Configuration
  • Cisco: Manual Configuration
  • Avaya: Manual Configuration

Knowledge Base Software powered by Helpjuice

Expand