Setup and Installation of AudioCodes MP202x Native Fax ATA
Table of Contents
Scope
This document will help you how to install an ATA to a Fax Machine.
Requirements
- Supported Native Fax ATA
- Note: This unit can only be used for faxing, it is NOT compatible with other devices. For ATA deployments, please use an FXO or FXA depending on requirements
- RJ45 Ethernet Cable
- Power Supply
- RJ11 Cable
- Fax Machine
Hook up the Fax ATA
- Connect the Ethernet Connector labeled “WAN” to your network.
- Connect the Telephone Port labeled PHONE 1 to the Fax Machine.
- Connect the Power. There is no ON/OFF (I/O)
- There is no ON/OFF (I/O) switch to the Fax ATA that turns on as soon as you connect the power.
- The POWER LED is lit (green) and when initialization completes (~1 minute),
- The STATUS LED changes from red to green.
Power Light Representation
- No Lights: Make sure power is connected
- Red Status Light: If the Status light remains solid red for longer than 5 minutes, contact our Support team
- Flashing Green Lights: If multiple green lights are flashing on the Fax ATA, it is downloading a firmware update or getting it's provisioning settings. DO NOT remove or disconnect power from the device at this time.
- WAN Status and Power lights are all green / 3 green lights: Normal Idle Status
- Multiple Red Lights / Mixed Green / Red Lights: The Fax ATA is rebooting. This typically takes about 60 seconds before going back to solid green.